New technologies replace the use of cheap additives, urea formaldehyde resin, in accordance with scientific theory and the corresponding technical means to produce chemical changes in the fiber to form a self-adhesive plastic synthetic boards. Sizing of MDF is to rely on urea production after the bonding glue curing effect, no chemical change in fiber, which is a physical bonding. New environmental fiberboard production process, through the additive effect in that the fibers to form new chemical compounds change in the system board repeated the process of chemical reaction, the final fiber bonding between the role of self-generated sheet made of, a chemical bonding. Neither formaldehyde pollution and low cost, is the interior decoration and furniture industries need environmental protection material, certainly the market, economic efficiency is far higher than the sizing of MDF. New technological features: direct use of existing MDF production line, without changing the device under the conditions of production, and applies to any plant fiber raw materials (raw materials, including woody and herbaceous plants). Production lines in China pilot were successful industrialization, and technology maturity. However, the production process in accordance with the chemical reaction, process demanding. Therefore, the function of production equipment must be in good condition, is particularly critical equipment - hot press hydraulic system functional integrity must be reliable, it can not adopt new technology. Interested manufacturers can try production, because they do not increase in equipment investment, as long as the pre-trial preparation of the full, just a working class to be completed trial production, such as continuous production can be satisfied with the product, if new products reach the agreed performance requirements , but a number of defective product, but not waste, still selling, and immediately to restore the original production process, economic risk is small, the success can bring huge benefits. |